June 2002 Tech Session
 
TRAC held a Tech Session at the home of TRAC's VP, Sherman Taffel on Saturday June 1.  During this session, members overlooked Sherman's measurement of his 1965 TR4's thrust washers.  Everything turned out fine as the crankshaft's end float was found to be in spec.





Group shot taken in Sherman's new garage.

The TR4 repair manual contains some very detailed drawings of the engine's interior.  This page shows how to measure the thrust washer end float - .006" is in spec.

New member, Phil Gelso discuss the finer points of the TR4 which Phil is preparing.



Would you trust your Triumph to the likes of these guys?
   

Return to Member Photo Page

Return to TRAC Home Page

Page Created on: 6/15/2002